Radio
In this project I focused on the use of the create polygon tool in Maya to make flat planes for the plates of the radio. From there i was able to extrude the plates back to my desired thickness. I feel the hardest challenge faced with this project was the ability to keep both curved shapes with sharp angles, most if this was reliant on the flow of the face plate meshes. Overall a very enjoyable project that required more of a focus on the flow of the wire frame.
Turntable of Radio.
Front Face Reference.
Front Face Close Up.
Front Face Close Up 2.
Back Plate Reference.
Back Plate Close Up.
Reference for pointed image as well as thickness of front plate.
Reference for bottom of Radio.
Reference for Side of Radio.
Wire framed angled view of the Radio's Front.
Shaded front of the Radio.
Smoothed wire frame angled view of the back of the radio.
Smoothed Shaded angled view of the back of the Radio.
Closer look at the Back plate wire-frame.
Closer look at the front wire frame.